Classification

Contact Us

501, 502 and 601, Building 4, Phase 2, Beijiao Kai Tak Real Estate Park, Shunde District, Foshan City, Guangdong Province

+86-13827784647

wanxia_sd@163.com

WX-T2002 degreaser

Keywords: water-based epoxy resin/water-based acrylic resin/water-based polyester resin.

Product Classification:

Telephone:

Product Details

1. Overview
WX-T2002 degreasing agent is an aqueous solution compounded by a variety of surfactants, metal corrosion inhibitors and cosolvents. It is suitable for degreasing of various metal products at medium and normal temperature. It has long service life and strong degreasing ability, and is suitable for the degreasing requirements of automatic production lines and immersion production lines.

2. use process
Process conditions: soaking, swimming immersion, ultrasonic cleaning.
Process flow: oil removal-water washing-post-process treatment.
Immerse the workpiece in the working fluid, after 10 minutes, the general grease on the surface of the workpiece can be removed, and check
The method of whether the grease is removed is: clean the surface residual liquid of the workpiece with water after oil removal, and observe whether the water film on the surface of the workpiece is continuous and complete. If so, it indicates that the oil has been removed.

3. technical indicators
Grooving: 5% groove, add the calculated amount of degreaser to the water.
Time: soak for 5-10 minutes, swim soak, ultrasonic for 5 minutes (according to the amount of oil, add compound degreasing
powder, can increase the efficiency of oil removal)
Temperature: normal temperature -60 ℃
PH:≥8
PH value detection method: direct detection with PH test paper.

4. tank maintenance
1. The degreasing fluid shall be tested for each shift, and the degreasing agent shall be supplemented according to the degreasing effect.
2. Remove the floating oil on the liquid surface in time. If the working liquid is saturated with oil or polluted, it needs to be discharged. Replace some tank liquid or replace the tank again. It is recommended to replace it every 3-6 months.
3. When a large amount of oil, dirt, dust and rust are mixed in the degreasing liquid, the solution can be left standing to clarify for more than 12 hours, the middle layer can be extracted with a submersible pump for reuse, the upper floating oil and the lower mud are discarded, and the degreasing agent is added.
4, for some adsorbed in the rust, oxide is difficult to remove the stubborn oil, can be used to remove the oil rust alternate treatment, can also increase the temperature of the oil tank or add a compound in addition to the oil powder.

5. considerations
1. Strictly control the relevant parameters of the working fluid and pay attention to maintaining a flat gap between the workpieces.
2, the operator must wear safety protection equipment.
3, if accidentally touched the skin, should immediately rinse with water.

Related Products